Cam profile overview
All displayed stages, generated from the switching programme.
Actual switch positions
No positions defined yet
Shaft return mechanism
No shaft returns defined
Top face profileBottom face profile
V2
Cam Switch Configurator
Build the switching programme first. The app derives actual switch positions, cam profiles, return paths, physical construction, and jumper wiring from that programme.
Switch details
Select a Cantak model and its published rated current, then add the project information.
Configuration valid
No cam conflicts, returns, or jumper warnings.
Switching programme
Each row represents one 15° physical cam sector. Positions are derived from closed contacts and continuous-cut midpoints.
Stage 1 Cantak upper/lower cam plate: within limits
Maximum total cut: 180° per profile.
Selected programme cell0° · 1–2
– unavailable sector× closed sector× continuous cutS0 spring to 0°SP spring to position
| Position | Angle | Return |
|---|---|---|
Physical switch construction
Complete all-angle construction derived from the switching programme.
Internal bridge: direct between terminal circlesExternal wires: separate colors and routing heights
No physical jumpers configured.
Global physical jumper wiring
Jumpers apply at every cam angle.
Allowed connection
Only valid terminal groups are available.
Jumper limitations used by this app
These are conservative generic engineering assumptions, not manufacturer-confirmed Secfetronik hardware rules.
Internal bridgeA short direct link between the two terminal circles in one stage: 1↔3 or 2↔4, then the equivalent connections in each following stage.
External wireConnects the same terminal position across two or three consecutive stages only, such as 1↔5, 2↔6, or 1↔5↔9.
Maximum external groupAn external connection is limited to two or three terminals. Longer groups are not offered.
Multi-terminal commonIf a terminal already participates in another jumper, the app warns that a common bus/branch is being created and combined current must be checked.
Not electrically validatedThe app does not know L1/L2/L3, circuit voltage, load, fault current, conductor size, or protective devices, so a physically allowed jumper may still be electrically unsafe.
Manufacturer confirmationRigid internal bridge availability, spacing, insulation, current rating, and layer restrictions must be confirmed for the actual switch series.
Ready. Changes are saved automatically in this browser.